Last Updated: 10/2/2011 – Copyright © Southern Deer Stands, LLC 2006-2011. All Rights Reserved

Applies to:

• Dura-Windows
• Flip Up Windows

Congratulations on your purchase of the best deer blind windows available – Texas Deer Blind Windows.  Your windows will provide with you years of service with very little maintenance required.  We have provided both installation instructions and suggested maintenance for years of maintenance free service.

Suggested Tools and Materials:
Power saw, screw driver or power drill, level, tape measure, square, screws and a helper (it is easier with two people)

Window Installation:
To aid in this example we will assume a flip up window that is 24” W x 10” H.

Cut your window opening:
The first step is to cut your window openings using a power saw. For our example window, a 24” X 10” we will need to cut the rough opening size to 22” by 8”.   This is so you have a 1” overlap of you window over your blind on all sides of the window, looking from the inside.  The window opening needs to be square. For our example window, a 24” X10” we will need to cut the rough opening size to 22” by 8”.

Test fit the window in the opening:
Once the window opening is cut you will need to test fit the window. The window will mount from the inside of the blind and you should be square against the opening.

Install the window:
Make sure the window is level and that you have 1 inch of clearance all the way around the window if looking at it from the inside, ideally the window should be flat against the inside wall. Once you have the window in the desired location start screwing the window hardware in place.  Start in the top left corner with one screw and then go the top right corner with one screw.  Test flip the window and make sure it still flips up freely, then add the last 2 screws in the top hardware mounts.  Next add 2 window latches to the sides or bottom when closed.  Last flip the window up and add 1window latch to the top to hold open the window.  Make sure they are tight enough to hold the window in place but lose enough to twist freely when opening or closing the window. Congratulations you are done!

Maintenance:
Depending on the amount of dust, fallen leaves, etc. in your area you may need to occasionally clean window.  For glass windows:  To clean the glass window panes use either Windex or soap and water.  For Dura-Windows: To clean the vinyl windows use only mild soap and water only.

If you need assistance:
If you have any questions or need help please call (214) 551-1530 and we will be glad to help.  Thank you for allowing us the opportunity to serve you.

Copyright © Southern Deer Stands, LLC 2006-2011. All Rights Reserved